click for full size image WARNING - LARGE FILE!!! Copyright © 2006, yellowjeep.com

The grain mill stand made from 1" square steel tube, using Chris' old motor. I had to flip the side plates inside out to place teh driven roller in the back so that the mill would turn the correct direction, I used a 12" pully from grainger and a belt I had laying around. the motor is mounted in a fixed position with4 5/16 screws and wingnuts, the mill is mounted in slots to adjust belt tension and tightened with 4 1/4-20 screws that thread into the existing holes on the grain mill, I took care tightening the screws to avoid putting stress on the side plates and adding friction on the brass bushings that the rollers ride on. To out-do Chris and his 5-gllon grain bin, (I just *had* to...) , I put on a 15 gallon one made from a industrial-size containter of simpel green that I cut the top off of.

File:	IMG_2204.JPG
Camera:	Canon EOS DIGITAL REBEL XT
Date/Time:	Wednesday, February 08, 2006, 10:11:32
Shutter speed:	1/60sec
Aperture:	f/4
Exposure mode:	Auto
Lens:	18 to 55mm @ 18mm
ISO:	400